Y3K RC

Models

01RC

Per-controller EdgeTX model configs. A model file encodes one radio's switches, mixes, and channels — so where the sounds are universal, every model here belongs to a specific controller.

RadioMaster MT12

internal ELRS · EdgeTX 2.12.1 · models/mt12/

Tr4ctor model00.yml

The original Tr4ctor profile — superseded by Tr4ctor2 below.
CAR3 model01.yml

Numbered surface-car slot.
CAR4 model02.yml

Numbered surface-car slot.
CAR5 model03.yml

Numbered surface-car slot.
Tr4ctor2 model04.yml

Three drive modes (Trail / Crawl / Climb on SA), speed-sensitive steering, trim-button sound triggers, mode-change voice announcements.
MT12 model59.yml

The radio's base slot.

RadioMaster Pocket

internal ELRS · EdgeTX 2.12.2 · models/pocket/

Y3Kradio model00.yml

Main radio profile / template.
FPV DRONE model01.yml

FPV quad profile.
DELTA model02.yml

Delta-wing.
HELI model03.yml

Helicopter profile.
SuperSPrnt model04.yml

Super Sprint surface car.
AIR model05.yml

General fixed-wing slot.
★ Titan24 model06.yml

Dual-stick 4WS crawler running the Crab Fader — front steer + throttle on the right stick, rear steer + hold-position crab stance on the left. Pocket + ER4 driving a Furitek Titan Buggy Ultimate 24. The full story →

Install a model

Grab the .yml for your radio from models/<controller>/.
Copy it into the card's BACKUP/.
On the radio, restore it from the model-select menu — safer than dropping straight into MODELS/.

Models are controller-specific (switch map, channel setup) — they won't map cleanly to other RadioMaster radios. And they're bind-phrase-free: ELRS keeps bind data in the module flash, not the model file, so you'll bind your own receivers.

Browse models/ on GitHub →